Category: Plumbing

Make Your Plumbing Repairs With This Information

Did you know that faulty air chambers might be why you are hearing a hammering sound in your pipes? The noise is known as water hammer and it may mean that water has entered your air chamber. Here are some tips to help you fix your problem.

As the weather begins to get cold, attend to all of your exposed pipes by adding insulation to them. Pay particular attention to pipes located in crawl spaces and the outside walls of your residence. Taking this step will help ensure that your pipes continue to function throughout the winter.

Before you start a plumbing project you should tighten all of the pipes that are easily accessible. Especially if your pipes are making a range of loud banging sounds, as this is a clear sign that there are loose pipes along the line. It is also a good idea in case there is a clog so the excess pressure released does not break a loose pipe.

The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.

Frequently inspect the floors around toilets for softness; this can tell you whether or not the floors are damaged. Sit reversed on the toilet (facing the tank) with your feet on the floor. Rock your weight onto each foot in turn and see if you can feel any weakness or “give” in the floor. Identify any damage and repair it before it gets worse. In the long run, you are likely to save money by not putting off the repair.

Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.

Have a specific plumber in mind before you have an emergency. Most people don’t think about plumbers until they find themselves having a big problem that needs to be fixed right away. Instead, choose a plumber who you are comfortable with and whose experience you trust–way before you actually need his services.

You know what can cause that hammering noise, plus a lot more plumbing information. You just saved yourself a lot of money if any of those issues became unbearable or resulted in broken parts. Take time to read back over this article periodically to make sure that you are on top of your plumbing skills.